Hydrogen Powered Generator

Hydrogen powered generator 

Gelsonlab HSPEN-009 Hydrogen gas system electricity generator ,hydrogen powered generator, Hydrogen fuel cell demonstration

In teaching students to learn and understand the principles of hydrogen energy generation.
In a transparent organic glass plate, the left side: power control board (containing 0-3V 0-1A DC DC voltmeter, ammeter, pressure regulating knob, switch and two banana plug jack) and 2 5# battery box, the banana jack; fuel cell module to water electrolysis as a 25*25mm platinum carbon proton exchange membrane; then make a hydrogen storage type water tank and a water storage type oxygen tank; fuel cell power generation module and the right to a 25*25mm platinum carbon membrane; the two banana jack; the right two parallel switch, a small vane motor, even a seven color wheel. Motor, voltage and current indicator board (containing a 0-5V DC voltage meter, a 0-100mA DC current meter). Overall size: 457*137*152mm.
The most left power control panel and the two most right electric appliances can be connected with the fuel cell water electrolysis module and the fuel cell power generation module respectively. The middle gas storage tank is connected with the water electrolysis module and the power generation module through a silicon rubber tube respectively.
In the experiment, Hydrogen Powered Generator can be used to head 4mm head 2mm banana plug to connect the power control board and the fuel cell module is connected with the water electrolysis line, another pair of banana plug connection line is connected with the fuel cell power generation module and external electric jack. The pure water or distilled water into the two gas tank until the water, and the water within the reaction window generation module; two 5#1.5V batteries into the battery box will, power switch on the control panel to dial "on", then the pressure regulating knob shifting to the maximum;; slightly, you can see the bubble start the gas tank, the water is electrolyzed into hydrogen and oxygen. After 2-3 minutes, the hydrogen and oxygen column column two gas tank, the water from the top; to see the voltage and current value of the voltage indicator plate reaches about 0.7V, to open a small vane or seven or seven rotary turntable, small leaves began to rotate. The hydrogen and oxygen in the fuel cell generation module through the reduction of proton exchange electrons with water, electric drive wind blades.

This is the principle of fuel cell power generation.

Note: 

1, because the fuel cell power generation module and two gas tank using silicone tube connection, will be full of pure air tube, so in the water before the first silicone tube connects the generator module to be opened, water electrolysis hydrogen and oxygen and power module are connected. If that doesn't have the electricity, can quickly open a gas power generation module at the lower part of the pipe plug, then immediately stopped, can carry out power generation.

2, the fuel cell module is dry water electrolysis, please be sure to charge the water and then connected to the power supply; while doing the experiment, the water must be pure water or deionized water, in order to avoid the pollution of fuel cell; and in the day after the end of the experiment, hard dry battery, back.
3, after the end of the experiment, the lower part of the gas storage tank can open the rubber plug, put dry inside the water, and wipe clean.
4, detailed experimental methods and notes can be detailed in the specification.

A type proton membrane area is 25*25mm